inteliLIGHT® FPM-152 LonWorks® PLC compatible – electronic ballast controller
Designed for carrying out the remote management of a luminary in street lighting installations InteliLIGHT® FPM- 152 is compatible with lamps using electromagnetic ballast up to 150W, for both HPS and MH HID lamps.
technical details
| Lamp Type | HID |
| Maximum lamp power | 150W |
| ON/ OFF function | yes |
| Dimming | yes |
| Dimming range | 30%-100% (depending on load) |
| Dimming steps | 1% |
| Control interface | internal |
| Network interface | PowerLine CENELEC-C band |
| Communication protocol | LONWORKS/ANSI709.1 |
| Retransmission mechanism | yes |
| Power supply | 230VAC / 50Hz – 60Hz |
| Overvoltage protection | 5 minutes @ 400VAC |
| Power consumption | Max. 2W |
| IP rating | IP67 |
| Operating temperature | -25°C to +65°C |
| Dimensions (length x width x height) | 110 x 75 x 51 mm |
| Certifications | CE, EN 50065-1 (2005), EN 50065-2-1 (2003),EN 61547 (2010), EN 55015 (2007), EN 61000-3-2 (2006), 60068-2-1 (2007),60068-2-2 (2007), ANSI/IEC 60529 |
measured parameters
| Lamp power | yes |
| Line voltage | yes |
| Current | yes |
| Active power | yes |
| Reactive power | yes |
| Apparent power | yes |
| Power factor | yes |
| Energy consumption (active/ reactive) | yes |
| Running hours | yes |
alarms monitored
| Over/ under voltage detection | yes |
| Over/ under current detection | yes |
| Lamp or ballast fault detection | yes |
| Device failure | yes |
configurable parameters
| Auto on enabled/disabled/ auto on time | yes |
| Auto off enabled/disabled/auto off time | yes |
| Start state: ON/OFF | yes |
| ON/OFF power threshold | yes |
| Overvoltage threshold | yes |
| Output transfer function | – |
| Strike retry count | yes |
| Fade time | – |
| Lamp warming time | yes |
| Lamp cooldown time | yes |
| Operation mode | ON/ OFF / dimming |
| Optional sensors available | Pole door open, pole impact detection, pole ground missing |
